FMUSER CA200 FM Antenna With Suction Pad for Car
- Price (USD): 35229
- Qty (PCS): 1
- Shipping (USD): 155
- Total (USD): 36779
- Shipping Method Payment: DHL
- Payment: PayPal
The FMUSER CA200 is a high-quality FM Antenna for the car. The rod of the antenna is waterproof and antirust for it is made of stainless steel, which guarantees the using life expectancy of the product. With adjustable frequency from 76-108 MHz, the speeds of the vehicle can be up to 120km/h within the antenna's safe range. Except for the 110mm's suction pad, we also have a high-quality spring placed on the bottom part of the antenna rod so as to enable the antenna to flexibly stick with the vehicle while there is a low height entrance of the garage, or branches of trees stretched out low.
Bendable in connecting part.
8 meters SYV-50-5 Pure Copper RF feeder cable.
Screw-in and out to adjust the frequency.
Stainless steel material, anti-rust.
CA200 is the upgrading version of the CA100 Car FM antenna, it has higher reliability in performance and can stand with RF power up to 150 Watts.
Stainless steel material, anti-rust, anti-rain, flexible.
A Flexible spring base enables the antenna to be bendable.
1* CA200 Antenna
1* CA200 Suction Pad
1* 8-meter SYV-50-5 Cable
Frequency: 76-108 MHz adjustable
RF power: 150watt
Frequency Range: 76~108 MHz
Band Width: 6 MHz
Gain: 3 dBi
Radiation: Full directions Omni
Lighting Protection: Direct Ground
Maximum Power Input-watts: 150 W
Height: 724±5 mm (adjustable by frequency)
Antenna Connector: BNC-female
Radiating Element Material: Stainless Steel
Video frequency input level: 1VP-P positive polarity
Video frequency input impedance: 75Ω
Luminance nonlinear: ≤10%
Group delay: ≤±60ns
The signal-to-clutter ration of low-frequency period interference: ≥50dB
Audio input level: 0dBm±6dB
Audio input impedance: 10KΩ (imbalance)/600Ω (Balance)
Maximum frequency deviation: ±50KHz
Harmonic distortion: ≤1%
The amplitude-frequency characteristics: ±1dB
Instruction of Adjusting the Frequency
Please note that the frequency of antenna and transmitter should match each other, so the transmitter can work well. See below the frequency adjusting. There are 4 steps:
1. Find out the Allen wrench in the package of the antenna.
2. Insert the Allen wrench into the Hexagon nut of the base, and screw out the nut.
3. Loosen the nut, pull out the rod, adjust to the length you need, and tighten the nut.
4. Be attention, the length of the antenna is counted from the nut to the blacktop. The table shows how to adjust the frequency according to the length of the antenna.
FMUSER INTERNATIONAL GROUP LIMITED.
We are always providing our customers with reliable products and considerate services.
If you would like to keep touch with us directly, please go to contact us